expresslrs ExpressLRS V3.6.3

[WaF Bot]

Changes since 3.6.2:

Bugfixes

• Allows updating backpack firmware via USB on S3 #3496
• Fix some STM32 builds because of PIO changes #3495
• Fix SPI clock rate for 80MHz STM32L432 devices #3493
• Disable PA when disabling TX & RX on ESP8285 #3485
• Extend VTX Admin disconnect debounce V3 #3460
• Extend tcpsocket idle timeout V3 #3444
• Only use the default UART0 for passthrough flashing #3441
• Fix LR1121 not committing power change when switching band V3 #3431
• Fix crash in CRSF parser with CRSF packet length 0 - V3 #3430

Other fixes and improvements

• Disable backpack in wifi and BLE modes V3 #3432
• Merge master elrs.lua changes #3463

Compatibility

This is a bugfix/patch release and is compatible with earlier 3.x versions.

Who should update from V3.6.2?

These are all backports from bugs found during 4.0.0-RC1 testing and seek to improve stability and performance for users experiencing:

• Rotorflight Configurator over wifi frequently disconnects before the tab can load
• Poor wifi / bluetooth connection stability caused by backpack being active when in these modes
• Telemetry stops updating when used with external telemetry sensors that generate malformed packets connected to the receiver
• SPI receivers constant connect/disconnect cycles due to VTX Admin on connect
• Note! elrs.lua from V4.0.0-RC2 (r16) can be used with 3.x as well. The version number has been removed and is compatible with ExpressLRS 2.x, 3.x, and 4.x

Lire la source